Wyse R90LE Especificaciones descargar pdf (Pagina 9)

Installing R90L Thin Client Flash 5

Step 2: Install the R90L Flash Module

Warning

Flash modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis

and keep that contact with the chassis during the installation process.

1. Note where the connector of the flash module is located in Figure 4. Use needle-nose

pliers to squeeze the plastic standoff lock as you rock the flash module back and forth

to remove it from the socket.

Figure 4 Removing the existing flash module

2. Install the new flash module in the reverse order of removing the original flash module.

Carefully press the flash module onto the standoff lock and connector, making sure to

lock it into place.

Step 3: Reassemble the R90L Thin Client

1. Replace the left side cover in the reverse order as described in "Step 1: Remove the

R90L Thin Client Left Side Cover."

2. Attach the vertical foot.

3. Reconnect the video display, keyboard, mouse, network cable, and power adapter to

the thin client before connecting to an electrical outlet.

Caution

Do not turn on the thin client. The thin client is ready to re-image, however

the flash module does not contain an operating system. Turning on power to

your thin client without firmware will display the error message “NO

OPERATING SYSTEM FOUND.”

What’s Next

Continue with "Installing WES2009 Firmware."

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Sin comentarios

Wyse R90LE Especificaciones Pagina 9