Wyse R90LE Especificaciones

Reference GuideWyse® R Class Conversion, XPe to WES2009Wyse® USB Firmware ToolTM Release 1.10Issue: 102910PN: 883887-16L Rev. C

6 Chapter 2This page intentionally blank.

3 Installing R90LE Thin Client FlashThis chapter contains information for users of Wyse R90LE thin clients who must install new flash. If you are inst

8 Chapter 3ProceduresStep 1: Remove the R90LE Thin Client Left Side CoverCautionFollow all precautions listed in the Quick-Start Guide that came with

Installing R90LE Thin Client Flash 9Step 2: Install the R90LE Flash ModuleWarningFlash modules may be susceptible to damage by Electro-Static Discharg

10 Chapter 3Figure 8 Removing the existing flash module3. Install the new flash module in the reverse order of removing the original flash module. Car

4 Installing WES2009 FirmwareThis chapter includes the requirements and procedures you need to install and use Wyse® USB Firmware ToolTM to update you

12 Chapter 4Step 3: Use Wyse USB Firmware Tool to Configure a Single USB Key to Convert Firmware1. Double-click the shortcut to run the tool and open

Installing WES2009 Firmware 134. Select the Windows Embedded Standard OS type option.5. Select the Update Firmware operation to perform option.NoteAlt

14 Chapter 4Figure 15 Prepare USB drive 11.Select the USB key onto which you want the configurations (you can use Refresh as needed to recognize an in

Installing WES2009 Firmware 15Step 5: Verifying Thin Client OperationAfter the thin client reboots, you can verify that the general client information

Copyright Notices© 2010, Wyse Technology Inc. All rights reserved.This manual and the software and firmware described in it are copyrighted. You may n

16 Chapter 4Step 6: Attach a Wyse Conversion Label and Microsoft License Label on Each Converted Thin ClientThe conversion kit is supplied with Wyse C

Installing WES2009 Firmware 17TroubleshootingThis section contains general troubleshooting information.USB Keys - Troubleshooting Boot IssuesDue to di

Reference GuideWyse® R Class Conversion, XPe to WES2009Issue: 102910Written and published by: Wyse Technology Inc., October 2010Created using FrameMak

Contents1 Introduction 1Kit Contents 1Overview 2Wyse Technical Support 2Related Documentation and Services 2Wyse Online Community 22 Installing R90L T

iv ContentsThis page intentionally blank.

1 IntroductionThis guide provides step-by-step instructions to convert R90L and R90LE thin clients from XPe to WES2009.CautionWES2009 firmware require

2 Chapter 1The Conversion Software Assembly DVD-ROM contains:• A PDF of this Reference Guide• Wyse USB Firmware Tool Release 1.10• R Class WES Convers

2 Installing R90L Thin Client FlashThis chapter contains information for users of Wyse R90L thin clients who must install new flash. If you are instal

4 Chapter 2ProceduresStep 1: Remove the R90L Thin Client Left Side CoverCautionFollow all precautions listed in the Quick-Start Guide that came with y

Installing R90L Thin Client Flash 5Step 2: Install the R90L Flash ModuleWarningFlash modules may be susceptible to damage by Electro-Static Discharge