Wyse X90cw WES7 software Guía de instalación descargar pdf (Pagina 7)

2 Installing X90cw Mobile Thin Client

Flash and RAM

This chapter contains information for users of Wyse X90cw mobile thin clients who must

install new flash and RAM. If you are installing firmware only, you can skip this chapter and

proceed to"Installing WES7 Firmware."

Requirements

• Small Phillips screwdriver

• (Optional) Container for holding screws

Warning

Flash and RAM modules may be susceptible to damage by Electro-Static

Discharge (ESD). All industry-standard cautions should be followed to avoid

ESD. Before you remove or install a module, touch any metal part of the

chassis and keep that contact with the chassis during the installation

process.

Procedures

Caution

Follow all precautions listed in the Quick-Start Guide that came with your

mobile thin client for disconnecting and reconnecting the mobile thin client.

1. Perform a proper shutdown of the mobile thin client by closing all files and ending your

session, and then pressing the power button to turn off the mobile thin client.

2. Unplug the power cord and power adapter, and remove any other cables from the

mobile thin client.

3. Position the mobile thin client to access the bottom flash and RAM covers.

4. Remove the screws from the flash cover using a small Phillips screwdriver as shown in

Figure 2.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Sin comentarios

Wyse X90cw WES7 software Guía de instalación Pagina 7