Wyse WES2009 2GF/1GR hardware/software Guía de instalación descargar pdf (Pagina 10)

6 Chapter 2

2. Install the thermal pad by peeling off the clear strip and placing it (with textured strip

facing up as shown in Figure 6) where the module was located. Make sure that the pad

does not interfere with the connector pins or module locking clamps, and then lightly

press to secure.

Figure 6 Installing thermal pad

3. Peel off the colored textured strip from the thermal pad as shown in Figure 7, and then

with its label facing down, install the new RAM module in the reverse order of removing

the original RAM module. Carefully press down on the RAM module until its retaining

clips lock it into place.

Figure 7 Installing new RAM module

Step 4: Reassemble the Cloud Client

1. Replace the top cover in the reverse order as described in "Step 1: Remove the Top

Cover."

2. Attach any vertical foot.

3. Reconnect the video display, keyboard, mouse, network cable, and power adapter to

the cloud client before connecting to an electrical outlet.

Caution

Do not turn on the cloud client. The cloud client is ready to re-image,

however the flash module does not contain an operating system. Turning on

power to your cloud client without firmware will display the error message

“NO OPERATING SYSTEM FOUND.”

What’s Next

Continue with "Installing WES2009 Firmware."

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Wyse WES2009 2GF/1GR hardware/software Guía de instalación Pagina 10