Wyse Winterm S10 Guía de instalación

Installation GuideWyse® SX0 to S90 Conversion KitIssue: 033108PN: 883887-08L Rev. A

4 Chapter 2Required Tools and MaterialsYou will need the following tools to install the kit:• #1 Phillips screwdriver• Needle-nose pliersWarningThe RA

Getting Started 54. Remove cover from the thin client by pulling up the rear edge of the cover while pressing the front edge slightly down and away fr

6 Chapter 2This page intentionally blank.

3 Installing the 512 MB RAM ModuleThis chapter provides information on how to install the RAM module in a Wyse SX0L thin client. Removing the Existing

8 Chapter 3Figure 3-2 Installing the New RAM ModuleWarningThe RAM module may be susceptible to damage by Electro-Static Discharge (ESD). All industry-

4 Installing the 512 MB Flash ModuleThis chapter provides information on how to install the 512 MB Flash kit in a Wyse SX0L thin client.Removing the E

10 Chapter 4Reassembling the Thin Client To reassemble the thin client:1. Replace the top cover in reverse order as described in "Removing the Th

5 Converting to the Windows XPe Operating SystemThis chapter provides information for converting Windows CE or the Wyse Linux operating system of your

12 Chapter 5Installing the XPe ConversionComplete the following steps to install the XPe operating system in your thin client.Preparing the PC for the

Converting to the Windows XPe Operating System 134. In the Add Image screen, browse to the XPE.i2d conversion image to upload into WSI. Be sure to use

iiCopyright Notice© 2008, Wyse Technology Inc. All rights reserved.This manual and the software and firmware described in it are copyrighted. You may

14 Chapter 5Step 4 – Completing the Conversion Process After loading the conversion image using WSI, the thin client should automatically reboot. If D

Converting to the Windows XPe Operating System 15Step 6 – Verifying the Thin Client’s OperationTo verify that the conversion kit has been installed pr

Installation GuideWyse® SX0 to S90 Conversion KitIssue: 033108Written and published by: Wyse Technology Inc., March 2008Created using FrameMaker® and

iiiThin Client Requirements ComplianceFCC ComplianceModel SX0 thin clients meet Class B requirements.IEC/EN ComplianceModel SX0 thin client meet Class

ivThis page intentionally blank.

Contents1 IntroductionAbout this Guide 1Organization of this Guide 1Wyse Technical Support 1Related Online Resources Available at Wyse 12 Getting Star

viThis page intentionally blank.

1 IntroductionThis guide enables users of Wyse SX0 thin clients to install 512 MB RAM and 512 MB Flash upgrades and convert their thin client to the W

2 Chapter 1Administrator, User, and ReadMe documentation for your thin client model are available at: http://www.wyse.com/manuals. Wyse Thin Computing

2 Getting StartedThis chapter provides information about the conversion kit warranty, kit contents, required tools, and how to remove the thin client’