Wyse 2G Flash/2G RAM Guía de instalación

Installation GuideWyse® X90L and X90Le Mobile Thin Clients Flash and Memory Upgrade KitIssue: 072310 PN: 883884-22L Rev. A

4Installing the Upgrade KitTo install the 1-GB, 2-GB, or 4-GB flash and one (1) 1-GB RAM Upgrade Kit in an X90L or X90Le mobile thin client:CautionFol

55. Using the plastic alignment tool carefully lift up the keyboard (start lifting at the arrow shown in Figure 7), and then lay keyboard facedown to

67. Install the new flash module in the reverse order of removing the old module. 8. To remove the existing RAM module, use your fingers to unlock the

7Verifying the Mobile Thin Client’s OperationTo verify that the mobile thin client works properly:1. Reconnect the power cord and power adapter, and t

8c. Click Shutdown in the XPE TEST window to shutdown the mobile thin client, see Figure 12.Figure 12 Shutting down from the XPE TEST window3. Press

9Figure 13 Client Information 5. Verify that the MAC address and Serial Number matches the serial number and MAC address on the mobile thin client.6.

10Attaching the Upgrade Serial LabelThe Wyse conversion kit is supplied with a serial label that must be attached to each mobile thin client. 1. Attac

11Figures1 Flash module types 22 RAM module types 23 Upgrade Serial Label 24 Recommended tools 35 Unsnapping the switch covers 46 Prying off the

Installation Guide Wyse® X90L and X90Le Mobile Thin Clients Flash and Memory Upgrade Kit Issue: 072310Written and published by: Wyse Technology Inc

iiCopyright Notice© 2010, Wyse Technology Inc. All rights reserved.This manual and the software and firmware described in it are copyrighted. You may

iiiRegulatory Compliance for Wyse ProductsBasic EMC and Safety Requirements Wyse appliances are compliant with the regulatory requirements in the regi

ivThis page intentionally blank.

ContentsAbout this Guide 1Finding the Information You Need in this Guide 1Wyse Technical Support 1Wyse Online Community 1Related Online Resources

vi ContentsThis page intentionally blank.

Wyse® X90L and X90Le Mobile Thin Clients Flash and Memory (RAM) Upgrade Kit Installation GuideAbout this GuideThis guide describes how to install the

2If you need to upgrade your operating system, contact Wyse Customer Support at: http://www.wyse.com/support.Wyse Thin Computing Software is available

3Required Tools and MaterialsYou will need the following recommended tools to install the kit:• Small Phillips screwdriver• Plastic alignment tools or