Wyse 1GF/1GR upgrade kit Guía de instalación

Installation GuideWyse® X90 and X90e Mobile Thin Clients Flash and Memory Upgrade KitIssue: 042810 PN: 883884-21L Rev. A

4Installing the Upgrade KitTo install the 1-GB or 2-GB flash and 1-GB RAM Upgrade Kit in an X90 or X90e mobile thin client:CautionFollow all precautio

55. To remove the existing flash module, depending on the type of module you have, you must either pull up the module in the direction as shown in Fig

67. To remove the existing RAM module, use your fingers to unlock the two locking clamps at either side of the module by pushing the clamps in the dir

7Verifying the Mobile Thin Client’s OperationTo verify that the mobile thin client works properly:1. Reconnect the power cord and power adapter, and t

8c. Click Shutdown in the XPE TEST window to shutdown the mobile thin client, see Figure 12.Figure 12 Shutting down from the XPE TEST window3. Press

9Figure 13 Client Information5. Verify that the MAC address and Serial Number matches the serial number and MAC address on the thin client.6. Verify

10Attaching the Upgrade Serial LabelThe Wyse conversion kit is supplied with a serial label that must be attached to each mobile thin client. Attach t

11Figures1 Flash module types 22 RAM module types 23 Upgrade Serial Label 34 Recommended tools 35 Removing bottom screws from access cover 46 Lif

Installation Guide Wyse® X90 and X90e Mobile Thin Clients Flash and Memory Upgrade Kit Issue: 042810Written and published by: Wyse Technology Inc.,

iiCopyright Notice© 2010, Wyse Technology Inc. All rights reserved.This manual and the software and firmware described in it are copyrighted. You may

iiiRegulatory Compliance for Wyse ProductsBasic EMC and Safety Requirements Wyse appliances are compliant with the regulatory requirements in the regi

ivThis page intentionally blank.

ContentsAbout this Guide 1Finding the Information You Need in this Guide 1Wyse Technical Support 1Wyse Online Community 1Related Online Resources

vi ContentsThis page intentionally blank.

Wyse® X90 and X90e Mobile Thin Clients Flash and Memory (RAM) Upgrade Kit Installation GuideAbout this GuideThis guide describes how to install the 1

2If you need to upgrade your operating system, contact Wyse Customer Support at: http://www.wyse.com/support.Wyse Thin Computing Software is available

3Figure 3 Upgrade Serial LabelRequired Tools and MaterialsYou will need the following recommended tools to install the kit:• Small Phillips screwdriv